After having analyzed the requirement on the aerodynamic earth’s surface rough- ness in two-dimensional distribution in the research field of interaction between land surface and atmosphere, this paper presents a new way to calculate the aerodynamic roughness using the earth’s surface geometric roughness retrieved from SAR (Synthetic Aperture Radar) and TM thermal infrared image data. On the one hand, the SPM (Small Perturbation Model) was used as a theoretical SAR backscattering model to describe the relationship between the SAR back- scattering coefficient and the earth’s surface geometric roughness and its dielectric constant re- trieved from the physical model between the soil thermal inertia and the soil surface moisture with the simultaneous TM thermal infrared image data and the ground microclimate data. On the basis of the SAR image matching with the TM image, the non-volume scattering surface geo- metric information was obtained from the SPM model at the TM image pixel scale, and the ground pixel surface’s equivalent geometric roughness—height standard RMS (Root Mean Square) was achieved from the geometric information by the transformation of the typical to- pographic factors. The vegetation (wheat, tree) height retrieved from spectrum model was also transferred into its equivalent geometric roughness. A completely two-dimensional distribution map of the equivalent geometric roughness over the experimental area was produced by the data mosaic technique. On the other hand, according to the atmospheric eddy currents theory, the aerodynamic surface roughness was iterated out with the atmosphere stability correction method using the wind and the temperature profiles data measured at several typical fields such as bare soil field and vegetation field. After having analyzed the effect of surface equivalent geo- metric roughness together with dynamic and thermodynamic factors on the aerodynamic surface roughness within the working area, this paper first establishes a scale transformation model to calc
ZHANG Renhua 1 ,WANG Jinfeng 1 ,ZHU Caiying 1,2 ,SUN Xiaomin 1 & ZHU Zhilin 1 1.Institute of Geographical Sciences and Natural Resources,Chinese Academy of Sciences,Beijing 100101,China
As well known, the methods of remote sensing and Bowen Ratio for retrieving surface flux are based on energy balance closure; however, in most cases, surface energy observed in experiment is lack of closure. There are two main causes for this: one is from the errors of the observation devices and the differences of their observational scale; the other lies in the effect of horizontal advection on the surface flux measurement. Therefore, it is very important to estimate the effects of horizontal advection quantitatively. Based on the local advection theory and the surface experiment, a model has been proposed for correcting the effect of horizontal advection on surface flux measurement, in which the relationship between the fetch of the measurement and pixel size for remote sensed data was considered. By means of numerical simulations, the sensitivities of the main parameters in the model and the scaling problems of horizontal advection were analyzed. At last, by using the observational data acquired in agricultural field with relatively homogeneous surface, the model was validated.
TIAN Jing, ZHANG Renhua, SUN Xiaomin, ZHU Zhilin & ZHOU Yanlian Key Laboratory of Ecosystem Network Observation and Modeling, Institute of Geographic Sciences and Natural Resources Research, Chinese Academy of Sciences, Beijing 100101, China
