A numerical method was used to study the natural ventilation in a rectangular enclosure with two symmetrical openings. In order to improve the natural ventilation efficiency, a fin was introduced into the enclosure.Steady-state heat transfer by laminar natural ventilation in a partially divided rectangular enclosure was investigated by numerically solving equations of mass, momentum and energy. Streamlines and isotherms were produced and heat transfer rate were calculated. A parametric study was carried out using the following parameters: Rayleigh number (1 × 103 - 1 × 106) , dimensionless length (0 - 0.7) and position values (-0. 7 - 0. 7). It is found that the Nusselt number is an increasing function of Rayleigh number. By comparing with no-fin case, it is concluded that fin can effectively enhance the natural ventilation in the enclosure.
Laminar natural convection in an enclosure divided by an adiabatic partition on its bottom with two unequal discrete heat sources was investigated numerically. The effect of the partition on the flow structure and heat transfer characteristics in enclosure under asymmetric heating condition was studied. The parameters are the Rayleigh number (1 × 104 ≤Ra≤1 × 106) and the height of partition (0≤h/H≤0. 70). The streamlines are produced for various Rayleigh numbers. The results reflected by variations of the average Nusselt number in terms of the height of partition illustrates the convection heat transfer in the enclosure. The role of the partition is to weaken or cut off the heat removal rate from the strong heat source to the weak heat source. It is analyzed that the optimum height of the partition to break the linkage between the strong and weak heat source increases with increasing Rayleigh number.
A partition solution implemented by a cold air curtain for two asymmetric discrete heat sources in a twodimensional rectangular enclosure was numerically studied. Main attentions were focused on the effects of Reynolds number, Grashof number, separation distance between heat sources, and buoyancy ratio. It is found that the airflow and heat transfer are not only determined by governing parameters, but also affected by boundary conditions. It is also found that nearly symmetry of flow structure corresponds to nearly thermal partition, and the symmetry can be enhanced when Reynolds number, separation distance and buoyancy ratio increase. In addition, it is observed that there is a minimum Reynolds number for obtaining nearly thermal partition, which increases when Grashof number increases.
Continuous measurement of ambient PM10 was performed by TEOM at a university campus for about one year from 20 November 2007 to 29 October 2008 in Changsha city of Hunan province.Indoor PM10 and PM2.5 concentration were measured by DustTrak simultaneously in order to describe the difference in concentration level and daily variations of particle mass concentration between different seasons,and to survey the influence of ambient particle on indoor air quality.During the survey period,the annual average PM10 concentration was found to be 117.63 μg/m3,with a mean value 121.88 μg/m3 in winter and 111.50 μg/m3 in spring.The temporal trend changed quickly from time to time,and the peak values were found in rush hours and in the evening.Ambient PM10 showed a good correlation with indoor PM10 and outdoor PM2.5 but not with indoor PM2.5.These results showed that PM10 was influenced by local source(such as traffic or fuel burning)and regional source.The correlation analysis has shown that ambient PM10 contributes substantial fraction to indoor PM10 but not to indoor PM2.5,which indicates other source may exist in the indoor environment.
TANG Meng,DENG Qi-hong,WANG Qi(School of Energy Science & Engineering,Central South University,Changsha,Hunan 410083,China)
Source apportionment of particulate matters with aerodynamic diameter less than 10 μm （PM10） was conducted in the suburban area of Changsha, China. PM10 samples for 24 h collected with TEOM 1400a and ACCU system in July and October 2008 were chemically analyzed by the wavelength dispersive X-ray fluorescence （WD-XRF）. Source appointment was implemented by the principal component analysis/absolute principal component analysis （PCA/APCA） to identify the possible sources and to quantify the contributions of the sources to PM10. Results show that as the PM10 concentration is increased from （85.6±43.7） μg/m3 in July 2008 to （107.6±35.7） μg/m^3 in October 2008, the concentrations of the anthropogenic elements （P, S, C1, K, Mn, Ni, Cu, Zn, and Pb） are basically increased but concentrations of the natural elements （Na, Mg, Al, Si, Ca, Ti, and Fe） are essentially decreased. Six main sources of PM10 are identified in the suburban of Changsha, China： soil dust, secondary aerosols, domestic oil combustion, waste incineration, traffic emission, and industrial emission contribute 57.7%, 24.0%, 9.8%, 5.0%, 2.0%, and 1.5%, respectively. Soil dust and secondary aerosols are the two major sources of particulate air pollution in suburban area of Changsha, China, so effective measures should be taken to control these two particulate pollutants.
