Nanocrystalline Cu-Ni-P alloys with average grain sizes of 7, 10 and 24 nm were synthesized by means of electrodeposition. The grain size dependences of tensile strength and hardness of the nanocrystalline Cu alloys were investigated. The breakdown of Hall-Petch relation was exhibited in both tensile strength and hardness.
The microstructures and hardness of pure Al samples subjected to plastic deformation with different tem- peratures and strain rates were investigated. The results showed that the strain-induced grain refinement is significantly benefited by increasing strain rate and reducing deformation temperature. The saturated size of refined subgrains in Al can be as small as about 240 nm in cryogenic dynamic plastic deformation （DPD）. Grain boundaries of the DPD Al samples are low-angle boundaries due to suppression of dynamic recovery during deformation. Agreement of the measured hardness with the empirical Hall-Petch relation extrapolated from the coarse-grained Al implies that the low-angle boundaries can contribute to strengthening as effective as the conventional grain boundaries.
Nanostructured （ns） materials, i.e., polycrystalline materials with grain sizes in the nanometer regime （typically below 100 nm）, have drawn considerable attention in the past decades due to their unique properties such as high strength and hardness. Wear resistance of ns materials, one of the most important properties for engineering materials, has been extensively investigated in the past decades. Obvious differences have been identified in friction and wear behaviors Between the ns materials and their corresponding coarse-grained （cg） counterparts, consistently correlating with their unique structure characteristics and mechanical properties. On the other hand, the superior tribological properties of ns materials illustrate their potential applications under contact loads. The present overview will summarize the important progresses achieved on friction and wear behaviors of ns metallic materials, including ultrafine-grained （ufg） materials in recent years. Tribological properties and effects on friction and wear behaviors of ns materials will be discussed under different wear conditions including abrasive wear, sliding wear, and fretting wear. Their correlations with mechanical properties will be analyzed. Perspectives on development of this field will be highlighted as well.
By means of dynamic plastic deformation （DPD） followed by thermal annealing, a mixed structure of micro-sized austenite grains embedded with nano-scale twin bundles （of about 20% in volume） has been synthesized in a 316L stainless steel （SS）. Such a 316L SS sample exhibits a tensile strength as high as 1001 MPa and an elongation-to-failure of about 23%. The much elevated strength originates from the presence of a considerable number of strengthening nano-twin bundles, while the ductility from the recrystallized grains. The superior strength-ductility combination achieved in the nano-twins-strengthened austenite steel demonstrates a novel approach for optimizing the mechanical properties in engineering materials.
G.Z. Liu, N.R. Tao and K. Lu Shenyang National Laboratory for Materials Science, Institute of Metal Research, Chinese Academy of Sciences, Shenyang 110016, China
