Radiation-induced 1/f noise degradation in the LM117 bipolar linear voltage regulator is studied. Based on the radiation-induced degradation mechanism of the output voltage, it is suggested that the band-gap reference subcircuit is the critical component which leads to the 1/f noise degradation of the LM117. The radiation makes the base surface current of the bipolar junction transistors of the band-gap reference subcircuit increase, which leads to an increase in the output 1/f noise of the LM117. Compared to the output voltage, the 1/f noise parameter is more sensitive, it may be used to evaluate the radiation resistance capability of LM117.
Silicon junction field effect transistors（JFETs） have been exposed to Co-（60）-rays to study radiationinduced effects on their dc characteristics and noise. The devices have been irradiated and measured at room temperature up to an accumulated 100 krad（Si） dose of radiation at a dose rate of 0.1 rad（Si）/s. During irradiation,the generation–recombination（g–r） noise increase has been observed while the dc characteristics of the transistors were kept unchanged. The increasing of the density of the same type point defects and their probability of trapping and detrapping carriers caused by irradiation have been used to explain the g–r noise amplitude increase, while the g–r noise characteristic frequency has only a slight change.
It is found that ionizing-radiation can lead to the base current and the 1/f noise degradations in PNP bipolar junction transistors. In this paper, it is suggested that the surface of the space charge region of the emitter-base junction is the main source of the base surface 1/f noise. A model is developed which identifies the parameters and describes their interactive contributions to the recombination current at the surface of the space charge region. Based on the theory of carrier number fluctuation and the model of surface recombination current, a 1/f noise model is developed. This model suggests that 1/f noise degradations are the result of the accumulation of oxide-trapped charges and interface states. Combining models of ELDRS, this model can explain the reason why the 1/f noise degradation is more severe at a low dose rate than at a high dose rate. The radiations were performed in a Co60 source up to a total dose of 700 Gy（Si）. The low dose rate was 0.001 Gy（Si）/s and the high dose rate was 0.1 Gy（Si）/s. The model accords well with the experimental results.
Ionizing-radiation-induced current gain degradation in NPN bipolar junction transistors is due to an increase in base current as a result of recombination at the surface of the device. A model is presented which identifies the physical mechanism responsible for current gain degradation. The increase in surface recombination velocity due to interface states results in an increase in base current. Besides, changing the surface potential along the base surface induced by the oxide-trapped charges can also lead to an increased base current. By combining the production mechanisms of oxide-trapped charges and interface states, this model can explain the fact that the current gain degradation is more severe at a low dose rate than at a high dose rate. The radiations were performed in a Co60 source up to a total dose of 70 krad（Si）. The low dose rate was 0.1 rad（Si）/s and the high dose rate was 10 rad（Si）/s. The model accords well with the experimental results.
Based on the elastic trap-assisted tunneling mechanism in high-κgate stacks,a quantum percolation tunneling current 1/fγ noise model is proposed by incorporating quantum tunneling theory into the quantum percolation model.We conclude that the noise amplitude of the PSD(Power Spectral Density)for three stages,namely the fresh device,one-layer BD(breakdown),and two-layer BD,increases from 10-22→10-14→10-8 A2/Hz.Meanwhile,the noise exponent γ for the three stages,has the 1/f2type(γ→2),1/fγ type(γ→1~2),and 1/f type(γ→1),respectively.The simulation results are in good agreement with the experimental results.This model reasonably interprets the correlation between the bi-layer breakdown and the tunneling 1/fγ noise amplitude dependence and 1/fγ noise exponent dependence.These results provide a theoretical basis for the high-κ gate stacks bi-layer breakdown noise characterization methods.
An analytical direct tunneling gate current model for cylindrical surrounding gate（CSG） MOSFETs with high-k gate stacks is developed. It is found that the direct tunneling gate current is a strong function of the gate＇s oxide thickness, but that it is less affected by the change in channel radius. It is also revealed that when the thickness of the equivalent oxide is constant, the thinner the first layer, the smaller the direct tunneling gate current.Moreover, it can be seen that the dielectric with a higher dielectric constant shows a lower tunneling current than expected. The accuracy of the analytical model is verified by the good agreement of its results with those obtained by the three-dimensional numerical device simulator ISE.
