Effects of reflowing temperature and time on the alloy layer of tinplate and its electrochemical behavior in 3.5%NaCl solution were investigated by electrochemical measurements and surface characterization.It is found that the amount of alloy layer increases with the increase of reflowing temperature and time.Then the corrosion potential of detinned tinplate shifts positively and the corrosion rate decreases.After being coupled with tin,the detinned tinplate acts as cathode and tin acts as anode initially.However,after being exposed for some time,the potential shifts of both detinned tinplate and tin reverse the polarity of the coupling system.The galvanic current density decreases with the increase of reflowing temperature and time.
The Ni-TiN nanocomposite film was successfully electrodeposited on brass copper substrates.The microstructures of the Ni-TiN nanocomposite film were investigated using scanning electron microscopy（SEM） and transmission electron microscopy（TEM）.Its average grain size was analyzed through X-ray diffraction（XRD）,and its anti-corrosion property was studied through potentiodynamic scanning curves and electrochemical impedance spectroscopy（EIS）.The results show that the morphology of Ni-TiN composite film is sensitively dependent on the electroplating current density,TiN nanoparticle concentration,solution stirring speed,bath temperature and pH value of solution.The average grain size of the optimized nanocomposite film is about 50 nm.Meanwhile,the Ni-TiN nanocomposite films are much more resistant to corrosion than pure Ni coatings.
A kind of environmental friendly anodizing routine for AZ91D magnesium alloy,based on an alkaline borate-potassium acid phthalate（KAP） electrolyte,was studied.The effect of KAP on the properties of the anodized film was investigated by scanning electron microscopy（SEM）,X-ray diffraction（XRD）,energy dispersive spectrometry（EDS）,potentiodynamic polarization and electrochemical impedance spectroscopy（EIS）,respectively.The results showed that the anodizing process,surface morphology,thickness,phase structure and corrosion resistance of the anodized film were strongly dependent on the concentration of KAP.In the presence of adequate KAP,a compact and smooth anodized film with excellent corrosion resistance was obtained.
The corrosion process of AZ91D magnesium alloy in neutral 1%(mass fraction) sodium chloride aqueous solution was investigated by electrochemical noise(EN),SEM and EDX. Fractal theory was primarily used to depict the corrosion process of the alloy. The fast wavelet transform(FWT),as well as the fast Fourier transform(FFT),was employed to analyze the EN data. The results show that the overall corrosion process can be described by three stages. The first stage corresponds to the pit nucleation and growth; the second stage involves the growth of a passive oxide layer; and the third stage involves reactivation. With increasing immersion time,fractal dimension increases fast initially,fluctuates in the medium and increases again at last. Pitting corrosion and fractal dimension increase due to the initiation and formation of pits in the initial and the end of immersion,while depresses due to the passivation in the medium period. The results of SEM and EDX support the above conclusions.
